Drives; Drive Positions - HP dx7510 - Microtower PC Service & Reference Manual
Service reference guide: hp compaq dx7510/dx7518 business pc
Hide thumbs
Also See for dx7510 - Microtower PC:
- Support list (34 pages) ,
- Illustrated parts & service map (4 pages)
Table of Contents
Advertisement
Drives
The computer supports up to five drives that may be installed in various configurations.
This section describes the procedure for replacing or upgrading the storage drives. A Torx T-15
screwdriver is needed to remove and install the guide screws on a drive.
Drive Positions
Figure 6-14
NOTE:
Bezel for model dx7510 shown.
1
Two 5.25-inch external drive bays for optional drives (optical drive shown)
2
One 3.5-inch external drive bay for optional drive (diskette drive shown)
3
Primary 3.5-inch internal hard drive bay
4
Secondary 3.5-inch internal hard drive bay for optional hard drive
To verify the type, size, and capacity of the storage devices installed in the computer, run Computer
Setup. Refer to the Computer Setup (F10) Utility Guide for more information.
46
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
Drive Positions
Hide quick links:
Advertisement
Table of Contents
