hit counter script
AEG L87485 FL User Manual
  1. Manuals
  2. Brands
  3. AEG Manuals
  4. Washer
  5. L87485 FL
  6. User manual
AEG L87485 FL User Manual

AEG L87485 FL User Manual

Electrolux
Hide thumbs Also See for L87485 FL:
Table of Contents

Advertisement

Quick Links

Download this manual
EN User manual
L 87485 FL

Advertisement

Table of Contents
loading

Related Manuals for AEG L87485 FL

Summary of Contents for AEG L87485 FL

  • Page 1 EN User manual L 87485 FL...

  • Page 2: Table Of Contents

    18. ENVIRONMENT CONCERNS ..........32 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –...

  • Page 3: Safety Information

    ENGLISH SAFETY INFORMATION Before the installation and use, read this manual carefully: • For your safety and the safety of your property • To help the environment • For the correct operation of the appli- ance. Always keep these instructions with the appliance also if you move or give it to a 1.3 General safety different person.

  • Page 4: Technical Information

    • Do not install and connect a damaged Electrical connection appliance. • Make sure that the appliance is earth- • Make sure to remove all packaging and transport bolts. • Make sure that the electrical informa- • Make sure that the mains plug is dis-...

  • Page 5: Product Description

    ENGLISH Water supply pressure Minimum 0,5 bar (0,05 MPa) Maximum 8 bar (0,8 MPa) Cold water Water supply Maximum load Cotton 8 kg Spin speed Maximum 1400 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 3.

  • Page 6: Accessories

    4. ACCESSORIES Spanner To remove the transit bolts. Plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. Anti-flood inlet hose To prevent possible leakage Plastic hose guide To connect the drain hose on the edge of a sink.
  • Page 7 ENGLISH • After 5 minutes from the end of the 6.2 Programme knob washing programme. Refer to 'At the end of programme'. Turn this knob to set a programme. The related programme indicator comes on. 6.3 Display The display shows: The temperature of the set programme Cold water The spin speed of the set programme...
  • Page 8 The detergent overdosing comes on at the end of the cy- cle when the appliance detects too much detergent. You cannot open the appliance door when the symbol is You can open the door only when the symbol goes off.

  • Page 9: Delay Start Button

    ENGLISH The extra rinse symbol comes on when this function is acti- vated. The value shows the total number of the rinses. The indicator bar is fully filled when you set to the maxi- mum number of rinses. The Stain symbol comes on when you activate the function. The Prewash symbol comes on when you activate the func- tion.

  • Page 10: Programmes

    10 www.aeg.com • To activate the function, press button 6.10 Temperature button and button at the same time Press button to change the default until the display shows the symbol temperature. When the display shows • To deactivate the function, press but-...
  • Page 11 ENGLISH Programme Type of load Cycle Functions Temperature Max. weight of load descrip- tion Συνθετικά Synthetic or mixed fabric Wash SPIN REDUC- 60° - Cold items with normal soil. Rinses TION Ακύρωση max. load 4 kg Short Ξεβγάλματος spin Πρόπλυση Επιπλέον...
  • Page 12 12 www.aeg.com Programme Type of load Cycle Functions Temperature Max. weight of load descrip- tion Στύψιμο/ All fabrics. Drain- SPIN REDUC- The maximum load of the age of TION ´Aδειασμα laundry is related to the type the wa- NO SPIN 0°...

  • Page 13: Consumption Values

    ENGLISH 5) Set the spin speed. Make sure that it agrees with the laundry. To select the DRAIN programme only, set the function NO SPIN. 6) Press 'Επιπλέον ξέβγαλμα' button to add rinses. With a low spin speed the appliance performs delicate rinses and a short spin.

  • Page 14: Before First Use

    14 www.aeg.com Programmes Load Energy con- Water con- Approxi- Remaining (Kg) sumption sumption (li- mate pro- moisture (kWh) tre) gramme duration (minutes) Cottons 60 °C Cottons 40 1.00 °C Synthetics 40 0.60 °C Delicates 40 0.70 °C Wool/Hand 0.35 wash 30 °C...

  • Page 15: Loading The Laundry

    ENGLISH 10. LOADING THE LAUNDRY Open the appliance door. Make sure not to put too much laun- dry in the drum. Put the laundry in the drum, one item at a time. Shake the items be- Close the door. fore you put them in the appliance. Make sure that no laundry stays between the seal and the door.

  • Page 16: Check The Position Of The Flap

    16 www.aeg.com The compartment for the stain remover. Put the product in the compartment and set the stain function before you start the programme. Flap for powder or liquid detergent Turn it (up or down) in the correct position to use powder or liq- uid detergent.

  • Page 17: Setting And Starting A Programme

    ENGLISH Measure out the detergent and the fabric conditioner. Carefully close the detergent dis- penser. Make sure that the flap does not cause a blockage when you close the drawer. 12. SETTING AND STARTING A PROGRAMME Turn the programme knob. The rela- Press button again to activate ted programme indicator comes on.

  • Page 18: At The End Of Programme

    18 www.aeg.com 12.6 Open the door If the temperature and level of the water in the drum are too While a programme or the delay start high, the door lock symbol stays operates, the appliance door is locked. on and you cannot open the door.

  • Page 19: Water Hardness

    ENGLISH • Button up pillowcases, close zippers, • Do not mix different types of deter- hooks and poppers. Tie up belts. gents. • Empty the pockets and unfold the • To help the environment, do not use items. more than the correct quantity of de- tergent.

  • Page 20: Care And Cleaning

    20 www.aeg.com 15. CARE AND CLEANING WARNING! CAUTION! Do not use alcohol, solvents or chemical products. Disconnect the appliance from the mains supply before you clean it. 15.3 Maintenance wash 15.1 Descaling With the low temperature programmes it is possible that some detergent stays in The water we use contains limescale.

  • Page 21: Detergent Dispenser

    ENGLISH 15.6 Detergent dispenser To clean the dispenser: Press the lever. Pull the dispenser out. Remove the top part of the liquid additive compartment. Clean all the parts with water. Clean the dispenser recess with a brush. Put back the dispenser in the recess. •...
  • Page 22 22 www.aeg.com To clean the drain pump: Open the drain pump door. Pull the flap out to remove it. Put a container below the recess of the drain pump to collect the water that flows out. Press the two levers and pull for- ward the drainage duct to let the water flow out.

  • Page 23: Emergency Drain

    ENGLISH Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. Put the flap back and close the drain pump door. 15.8 The inlet hose filter and •...

  • Page 24: Troubleshooting

    24 www.aeg.com Put the drainage duct back and close the Close the water tap. drain pump flap. Remove the water inlet hose When you drain the water with the emer- Put the two ends of the inlet hose in gency drain procedure, you must acti-...
  • Page 25 ENGLISH Problem Possible cause Possible solution The appliance The water drain hose is Make sure that the water drain does not drain the damaged. hose has no damages. water. The filter of the drain Clean the filter of the drain pump is blocked.

  • Page 26: Installation

    26 www.aeg.com Problem Possible cause Possible solution Leakages from the drain Make sure that the drain pump pump. filter is tight. The water drain hose is Make sure that the water inlet damaged. hose has no damages. You cannot open...
  • Page 27 ENGLISH 17.2 Unpacking Use the gloves. Remove the external film. If necessary, use a cutter. Remove the cardboard top. Remove the polystyrene packaging materials. Remove the internal film. Open the door. Remove the poly- styrene piece from the door seal and all the items from the drum.
  • Page 28 28 www.aeg.com Put one of the polystyrene packag- ing elements on the floor behind the appliance. Carefully put down the appliance with the rear side on it. Make sure not to damage the ho- ses. Remove the polystyrene protection from the bottom.

  • Page 29: Positioning And Levelling

    ENGLISH Put the plastic caps in the holes. You can find these caps in the user manual bag. WARNING! We recommend that you keep Remove all the packaging and the packaging and the transit the transit bolts before you install bolts for when you move the ap- the appliance.

  • Page 30: Water Drainage

    30 www.aeg.com 17.4 The inlet hose • Connect the hose to the appliance. Turn the inlet hose only left or right. Loose the ring nut to set it in the cor- rect position. • Connect the water inlet hose to the cold water tap with 3/4 thread.
  • Page 31 ENGLISH With the plastic hose guide. • On the edge of a sink. • Make sure that the plastic guide can- not move when the appliance drains. Attach the guide to the water tap or the wall. • To a stand pipe with vent-hole. Refer to the illustration.

  • Page 32: Environment Concerns

    32 www.aeg.com You can extend the drain hose to maximum 400 cm. Contact the service centre for the other drain hose and the extension. 18. ENVIRONMENT CONCERNS Recycle the materials with the appliances. Do not dispose symbol . Put the packaging in appliances marked with the symbol applicable containers to recycle it.
  • Page 33 ENGLISH...
  • Page 34 34 www.aeg.com...
  • Page 35 ENGLISH...
  • Page 36 www.aeg.com/shop...

Table of Contents