Ipv6 Mtu - Dell Networking 7048 Reference Manual
Powerconnect 7000 series systems
Hide thumbs
Also See for Networking 7048:
- Release note (74 pages) ,
- Configuration manual (1270 pages) ,
- Reference manual (17 pages)
Advertisement
ipv6 mtu
Use the ipv6 mtu command in Interface Configuration mode to set the
maximum transmission unit (MTU) size, in bytes, of IPv6 packets on an
interface. This command replaces the default MTU with a new MTU value.
The IPv6 MTU is only observed for packets originating on the switch. Packets
forwarded by the hardware ignore the IPv6 MTU.
Syntax
bytes
ipv6 mtu <
no ipv6 mtu
Parameter Description
Parameter
bytes
Default Configuration
The default MTU is 1500.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the maximum transmission unit (MTU) size, in
bytes, of IPv6 packets.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 mtu 1300
>
Description
The maximum transmission size of an IPv6 frame. (Range:
1280-1500)
IPv6 Routing Commands
1069
- Quick Links:
- Dhcp Snooping
Hide quick links:
Advertisement
Chapters
