Table of Contents
Advertisement
Available languages
Available languages
2. Connect the power cable.
When the power cable has been
connected, the wiring monitor indicator
on the rear of the drives (orange) will light
up.
When the termination switch of the drive
is set to on, the termination indicator
(green) will light up.
Wiring monitor indicator
Termination indicator
ABOUT REGION CODES
Region codes are part of the DVD standard. There is a Region number located within
one or all of the components required for DVD-VIDEO playback.
The region code on the DVD-R7322 can be changed ONLY 5 times, including the 1st
setting. Please be aware that the 5th change will be PERMANENT. Therefore please
use caution when changing the region code.
NOTE:
The method of changing the Region number will vary depending on the Decoder/
Operating System used.
Power cable
TO INSTALL THE DRIVE
3. Connect the changer interface cable.
When the changer interface cable has
been connected, the wiring monitor
indicators will flash at two-second
intervals.
Wiring monitor indicator
Changer interface cable
NOTE:
Connect the changer interface cable to the
connector corresponding to the bay in which
the drives have been installed. (Note that labels
are affixed to connectors indicating the
corresponding bay number.) Note that it is
extremely important to do this, as connecting
the changer interface cable to a neighboring bay
will result in damage to discs and the disc
transport mechanism.
4. Connect SCSI cables.
The way in which SCSI cables should be
connected differs depending on how the
changer is to be configured. For further
information on how to connect SCSI cables,
see the operating instructions for the DRM-
7000 disc changer.
9
En
Advertisement
Table of Contents
