hit counter script
Download Print this page
GE ZBD7000G00II, ZBD7005GII Installation Instructions
GE ZBD7000G00II, ZBD7005GII Installation Instructions

GE ZBD7000G00II, ZBD7005GII Installation Instructions

Professional style stainless steel door panel kit for zbd7000gii and zbd7005gii

Advertisement

Quick Links

Installation
Ilnstruct ons
[]
Laythe dishwasher on its back.
[]
Secure the panel to the door by inserting the top
and bottom shoulder washers into the matching
keyhole slots. Make sure all 4 washers engage the
keyhole slots.
Stainless
ZPRO7000S
Professional
Style
Stainless
Steel
Door Panel
Kit
For ZBD7000GII
and ZBD7005GII
[]
[]
[]
[]
Press the panel againstthe door and push downwards
until the washers are fully engaged into the keyhole slots.
The panel should align evenly with the top and sides,
Stand the dishwasher upright.
Open dishwasher
door and drive
the supplied
#6 x 2 Phillips
screws through
the inner door
and into the
f_
panel. Drive
one screw at
the top and then
one screw on each
side as shown.
Stainless
SteelPanel
Door springs must be
installed in the correct position.
Position
Left Side
Riqht Side
Front
N/A
Blue
Rear
Green
Green
See Spring Removal instructions below.
TO REMOVE THE SPRING AND SPRING SUPPORT ROD
[]
Close the door and lift the bottom of the support rod
upward and away from the slot in the door hinge.
[]
Pull the rod downward from the guide in the
side plate.
[]
Remove the spring and spring sleeve from the rod.
[]
Reassemble in reverse order.
NOTES:
• The front spring sleeves and support rods are different
from the rear ones. When comparing the two support
rods, the front rods have two extra 5/32" diameter
round lugs approximately 1/3 of the way along the rod;
the rear rods do not have these lugs. The external
spring sleeve for the front spring assembly is the
longer of the two. If the front rod and front sleeve are
installed in the rear position, the door will not open all
the way and the rod is likely to come off when the door
is closed, Make sure the correct assemblies are
reinstalled in the correct positions.
LightTrigger
Viewing
Hole
• Take care notto damage the interior lighttrigger
operated by the right hand front support rod.
• A spring and support rod must always be present in the
right hand front position to activate the light trigger,
Pub,No, 31-30573
]
]
PartNo, 20601559Pl13
03-04JR
Printedin tile United States

Advertisement

loading

This manual is also suitable for:

Zpro7000s