Related Manuals for GE Monogram ZXR7510
Summary of Contents for GE Monogram ZXR7510
- Page 1 Installation Instructions If you have questions, call 800.GE.CARES or visit our website at: www.monogram.com ZXR758 and ZXR7510 Recirculating Accessories For Model ZV750, Vent Hood...
-
Page 2: Table Of Contents
BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT • – Save these instructions for local inspector’s use. IMPORTANT • – Observe all governing codes and ordinances. Note to Installer • – Be sure to leave these instruc- tions with the Consumer. Note to Consumer •... -
Page 3: Installation Preparation
ZV750. Choose the correct kit according to ceiling heights: ZXR758 – For 8 to 9 ft. ceiling height. ZXR7510 – For 9 to 10 ft. ceiling height. PRODUCT DIMENSIONS The vent hood must be installed 24" min. and 30" max. -
Page 4: Duct Cover Accessories
DUCT COVER ACCESSORIES A duct cover accessory is required for recirculating operation. Use this chart to determine which accessory is required for your ceiling height. ZV750SY Installation Heights Actual Ceiling * Possible Hood Height Installation Height 24-1/2″ 7′ 11″ 25-1/2″ 8′... -
Page 5: Remove Packaging, Check Contents
• Install strain relief onto junction box. • Drill 1/8" Pilot Holes For Mounting Brackets. • Drill 1/8" Pilot Holes. Wall Mount Template 2 Mounting Brackets Check contents of the required accessory, ZXR758 or ZXR7510. Duct 2 Phillips Head Decorative Screws Junction Knockout... -
Page 6: Installation Instructions
Align edge 25-1/2" above Cooking Surface. For ZXR758 – 26-1/4" to 38-1/2" for 8 ft. to 9 ft. ceilings. For ZXR7510 – 38-1/4" to 50-1/4" for 9 ft. to 10 ft. ceilings. • Use a level to draw a line straight up, from the centerline on the template to the ceiling. -
Page 7: Step 3, Install The Hood
3 INSTALL THE HOOD Place the hood on the brackets and slide left to right to align with rectangular slots at the top. Screws “B” To Secure Hood To Wall • Adjust the installation height by tightening or loosening the screws “A” at the bottom of the brackets. -
Page 8: Step 6, Connect Electrical
• Separate the duct covers supplied with the hood. • Discard the upper (inner) section. • Insert the ZXR758 or ZXR7510 duct cover (with vent holes) into the original lower section. Be sure that the new duct section is inside the shorter original section. -
Page 9: Step 8, Install Filters
Installation Instructions 8 INSTALL FILTERS Upper Charcoal Filter Slots Lower Grease Filter Slots • There are two slots inside the back and front of the hood. These slots will hold the charcoal filters and stainless steel grease filters in place. Install Charcoal Filters Upper Charcoal Filter Slots... - Page 12 Note: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram 1.800.444.1845. Note: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. GE Consumer & Industrial GE Appliances General Electric Company Louisville, KY 40225...