Schematic Diagrams And Printed Wiring Boards - Sony Trinitron HMD-A230 Service Manual
17vc chassis color computer display
Hide thumbs
Also See for Trinitron HMD-A230:
- Operating instructions manual (52 pages) ,
- Service manual (71 pages)
Table of Contents
Advertisement
4-4. SCHEMATIC DIAGRAMS AND PRINTED WIRING BOARDS
Note:
• All capacitors are in µF unless otherwise noted. (pF: µµF)
Capacitors without voltage indication are all 50 V.
• Indication of resistance, which does not have one for rating electrical power, is as follows.
Pitch: 5 mm
Rating electrical power 1/4 W (CHIP : 1/10 W)
• All resistors are in ohms.
•
: nonflammable resistor.
•
: fusible resistor.
T
•
:internal component.
•
: panel designation, and adjustment for repair.
• All variable and adjustable resistors have characteristic curve B, unless otherwise noted.
•
: earth-ground.
•
: earth-chassis.
[
• The components identified by
in this basic schematic diagram have been carefully factory-selected for each
set in order to satisfy regulations regarding X-ray radiation.
Should replacement be required, replace only with the value originally used.
• When replacing components identified by
• When replacing the part in below table, be sure to perform the related adjustment.
• All voltages are in V.
• Readings are taken with a 10 MΩ digital multimeter.
• Readings are taken with a color-bar signal input.
• Voltage variations may be noted due to normal production tolerances.
•
: Can not be measured.
*
• Circled numbers are waveform references.
•
: B + bus.
•
: B – bus.
Note: The components identified by shading and
mark ! are critical for safety. Replace only
with part number specified.
Note: Les composants identifiés par un tramé et
une marque ! sont critiques pour la
sécurité. Ne les remplacer que par une pièce
portant le numéro spécifié.
]
, make the necessary adjustments indicated. (See page 2-1)
• Divided circuit diagram
One sheet of D board circuit diagram is divided into three sheets,
each having the code D-a to D-c. For example, the destination
ab1 on the code D-a sheet is connected to ab1 on the D-b sheet.
a b 1
Ref. No.
Circuit diagram division code
- Quick Links:
- Timing Specification
Hide quick links:
Advertisement
Table of Contents
