Please read this entire manual before proceeding IMPORTANT Local codes vary. Installation, electrical connections, circuit breakers and grounding must comply with all applicable codes. Save these instructions for your local electrical inspector's use. INSTALLER: Please leave these Installation Instructions with this unit for the owner.
• Grommet (1) • Template (1) Caution: • Trim kits are designed for use only with the Thermador microwave oven models listed (See Table 1). • For safety, do not alter or modify any part of this kit or oven.
Your microwave oven can be installed into a Figure 1. cabinet or wall by itself or above any of the following Thermador wall ovens: C271, C301, • It is a good practice when the microwave oven CM301, S301, SC301. Or, Thermador Warm- is installed at the end of a cabinet run, adja- ing Drawers WD27 and WD30 (see Figure 2).
Step 3: Electrical Installation The Thermador microwave oven is equipped with a grounded cord. The wall receptacle must be installed and grounded in accordance with the national electrical code. Also, electrical connections and grounding must comply with all applicable local codes.
Step 5: Installing The Microwave Oven Note: The four (4) ducts have a plastic cov- Position Side Duct on left side of oven. Fasten with outer case screw removed in ering that must be removed prior to install- ing them onto the microwave. Step 2.
Page 7
Figure 5 11. Re-install the left side vertical trim bracket (MT27B only). 12. Snap on the frame trim with the Thermador logo above the microwave door (Figure 6). Frame Trim 13. Install the turntable support and the turntable inside the microwave oven.
Thermador reserves the right to change specifications or design without notice. Some models are certified for use in Canada. Thermador is not responsible for products which are transported from the United States for use in Canada. Check with your local Canadian distributor or dealer. Thermador, 5551 McFadden Avenue, Huntington Beach, CA 92649.