Download Print this page

General Operation; Overnight Burn - Nectre Fireplaces 800 Operating Instructions Manual

Wall heater

Hide thumbs Also See for 800:

Table of Contents

GENERAL OPERATION

Once the heater has been burning on high for approximately 20 to 30 minutes it

will have reached operating temperature. You may now slow the burn down by

adjusting the air slide into the closed position. Turn the fan on to the preferred

speed setting.

When adding wood, open the air slide fully, wait a few seconds, then open the

door slowly. After re-loading, leave air slide open, on high for 15 - 20 mins to

allow new fuel to catch freely and entirely.

Then re-adjust the air slide to desired setting for maximum efficiency. If the fire

is too small, refuelling first with kindling is advised.

An overnight burn can be achieved by following these steps an hour before

retiring:

1) Open air slide fully

2) Load with large pieces of dry wood

3) When all wood is burning, slowly move the air slide to low position.

4) Turn fan to OFF position.

NOTE: This procedure can be done at any time, for example, in the morning so

that the fire is still going later that day.

Table of Contents

Show Quick Links

Table of Contents