hit counter script
Toro CCR Powerlite 38182 Operator's Manual
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Snow Blower
  5. CCR POWERLITE 38182
  6. Operator's manual
Toro CCR Powerlite 38182 Operator's Manual

Toro CCR Powerlite 38182 Operator's Manual

Hide thumbs Also See for CCR Powerlite 38182:
Table of Contents

Advertisement

Quick Links

CCR Powerlite® Snowthrower
Model No. 38182—Serial No. 270000001 and Up
Introduction
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a dealer,
or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model and
serial numbers of your product ready. Figure 1 identifies the
location of the model and serial numbers on the product.
Write the numbers in the space provided.
Figure 1
1. Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 2),
which signals a hazard that may cause serious injury or
death if you do not follow the recommended precautions.
Figure 2
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
Important: This engine is not equipped with a
spark arrester muffler. It is a violation of California
Public Resource Code Section 4442 to use or operate
this engine on any forest-covered, brush-covered, or
grass-covered land. Other states or federal areas may
have similar laws.
This spark ignition system complies with Canadian
ICES-002
The enclosed Engine Owner's Manual is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California Emission
Control Regulation of emission systems, maintenance,
and warranty. Replacements may be ordered through
the engine manufacturer.
Safety
Read and understand the contents of this manual
before the engine is ever started.
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
Improperly using or maintaining this snowthrower
could result in injury or death. To reduce this potential,
comply with the following safety instructions.
This snow thrower is capable of amputating hands and
feet and throwing objects. Failure to observe the following
safety instructions could result in serious injury.
Register at www.Toro.com.
Form No. 3355-415 Rev A
Operator's Manual
Warning
CALIFORNIA
Proposition 65 Warning
Original Instructions (EN)
Printed in the USA
All Rights Reserved

Advertisement

Table of Contents
loading

Related Manuals for Toro CCR Powerlite 38182

Summary of Contents for Toro CCR Powerlite 38182

  • Page 1 Other states or federal areas may additional information, contact an Authorized Service have similar laws. Dealer or Toro Customer Service and have the model and serial numbers of your product ready. Figure 1 identifies the This spark ignition system complies with Canadian location of the model and serial numbers on the product.
  • Page 2 Training to protect eyes from foreign objects that may be thrown from the machine. • Read, understand and follow all instructions on the machine and in the manual(s) before operating this unit. Operation Be thoroughly familiar with the controls and the proper use of the equipment.

  • Page 3: Clearing A Clogged Discharge Chute

    Run the machine a few minutes after throwing snow to prevent freeze-up of the rotor blades. Toro Snowthrower Safety The following list contains safety information specific to Toro products or other safety information that you must know. • Rotating rotor blades can injure fingers or hands.

  • Page 4: Safety And Instructional Decals

    Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. 61-4790 112-6646 104-2767 104-2768 112-6647 Reorder part no. 112-8101...

  • Page 5: Loose Parts

    Setup Loose Parts Use the chart below to verify that all parts have been shipped. Step Qty. Description Oval-head bolts Curved washers Install the handle. Handle knobs Discharge chute Washers Install the discharge chute. Locknuts Knob 1. Installing the Handle 2.

  • Page 6: Product Overview

    Mixing the Gasoline and Oil 3. Handle 6. Fuel tank This snowthrower uses a 50:1 gasoline-to-oil mixture. Use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added) or an equivalent high-grade, NMMA TCW III-certified two-cycle oil. Important: To prevent engine damage, do not use automotive oil (such as SAE 30 or 10W30) or fuel mixed at the wrong gasoline-to-oil ratio.

  • Page 7: Filling The Fuel Tank

    Important: Run the electric starter no more 4. Shake the container to mix the gasoline and oil thoroughly. than 10 times at intervals of 5 seconds on, then 5 seconds off. Running the electric starter 5. Slowly remove the cap and add the remaining amount extensively can overheat and damage it.

  • Page 8: Operating Tips

    Operating Tips The more you tilt the handle forward, the faster the snowthrower self-propels. • If the snowthrower does not propel itself forward on slippery surfaces or in heavy snow, push forward on The rotor blades can throw stones, toys, and other the handle, but allow the snowthrower to work at its foreign objects and cause serious personal injury to own pace.

  • Page 9: Inspecting The Rotor Blades

    1. Add a fuel stabilizer/conditioner to the fuel in the fuel Inspecting the Scraper tank as directed. Note: If you use Toro 50:1 2-Cycle Oil (Fuel Before each season, inspect the scraper for wear. If the thickness from the top of the wear indicator groove to Stabilizer Added), you do not need to add a fuel the bottom of the scraper is less than 1/16 inch (1.6 mm)

  • Page 10: Folding The Handle

    Folding the Handle 1. Remove the knob from the rear of the discharge chute. 2. Fold the discharge chute down and install the knob tightly onto the bolt at the rear of the discharge chute handle (Figure 12). Figure 12 3.
  • Page 12 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatised with your Distributor’s service or have difculty obtaining guarantee information, contact the Toro importer.

This manual is also suitable for:

38182Ccr powerlite

Table of Contents