Table of Contents
Advertisement
Available languages
Available languages
MicroDrawer™ Microwave Oven Measurements
Figures 2, 3 and 4 contain
oven measurements for reference when planning the drawer's
location.
This MicroDrawer™ microwave oven c
any electric or gas wall oven.
Anti-Tip Block
NORMAL INSTALLATION STEPS
Anti-Tip Block Installation Instructions
The anti-tip block reduces the risk of drawer tipping when installed properly.
Install the anti-tip block 14 13/16 inches above the installation opening floor
(where the unit will sit) for a standard installation or 14 5/8 inches for a flush
installation. The 6-inch Anti-Tip block must be provided by the installer. See
Figure 3 (standard installation) or Figure 4 (flush installation) and Figure 5. The
Anti-Tip block prevents serious injury that might result from spilled hot liquids.
If the MicroDrawer™ microwave oven is ever moved to a different location, the
Anti-Tip block must also be moved and installed. If the anti-tip block is to be anchored to the wall make certain that the screws
holding it penetrate into the structural members (studs) behind any covering such as drywall.
Make sure that the screws do not contact any wiring or plumbing that may be present in the wall.
CAUTION
WARNING
The unit can tip and cause spills and potential burns or other injuries if the anti-tip block is not installed correctly.
FLUSH INSTALLATION DIMENSIONS AND CLEARANCES
many MicroDrawer™ microwave
an be installed below
Ubicación del
tomacorriente eléctrico*
Figure 4
NOTICE:
Always allow sufficient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.
5" (127 mm)
4"
(101.6 mm)
6"
(153 mm)
Bloque
antivolcaduras
3 1/2"
(89 mm)
Figure 5
English 5
Advertisement
Chapters
Table of Contents
