Table of Contents
Advertisement
CD
YC SEP(Y/C separation filter)/7 bntton
1
l
and lamps
For NTSC or PAL signal, select the filter to be
used for Y/C separation. Press the button so that
the lamp of the appropriate filter lights.
COMB: To use the comb filter with the comb
filter board (BB or BT) installed.
TRAP: To use the built-in trap filter.
&ml
When the appropriate comb filter board has not
been installed, the trap filter is activated regardless
of the setting with this button.
Cf)
WHITE BALANCE/8 button
1
l and lamps
Select the white balance and picture levels stored
in the respective registers. Press this button so that
the lamp of the appropriate register lights.
At the factory, the white balance for D65 has been
stored in all the registers.
D65/D93 RO: To use the white balance and picture
levels stored in register 0.
MEM 1 Rt: To use the white balance and picture
levels stored in register 1 .
MEM 2 R2: To use the white balance and picture
levels stored in register 2.
MEM 3 R3: To use the white balance and picture
levels stored in register 3.
For details, see "1-4. Menu Operations."
@ASPECT/9
button
1
l and lamps
Select the aspect ratio of the picture to be
monitored. Press this button so that the lamp of
the appropriate ratio lights.
4:3: For the 4:3 aspect
16:9: For the 16:9 aspect
«>
LOCAL/REMOTE/0 buttonll and lamp
To enable the monitor to be controlled from an
external control device connected to the REMOTE
connector on the rear panel, press this button so
that the lamp lights (REMOTE mode). To disable
the remote control (LOCAL mode), press the
button again.
For the remote control.fimctions, see "1-4-6. Assigning
the Remote Control Functions."
1) These buttons also function as numeric keys when
specifying the password.
See "1-4-5. Changing and Applying the Password."
G,
MENU button
Press to initiate menu operations. The initial menu
is displayed.
c@
ESC (escape) button
Press to quit menu or auto setup operations.
CD
SEL (select) button
Press to set the monitor to color temperature
selection mode in auto setup operations. In color
analyzer mode, select the memory position of the
probe connected to the AUTO SETUP PROBE
connector.
For details, refer to the operation and maintenance
manual of the BKM-2056 auto set-up adaptor.
Cli)
ENT (enter) button
Press to proceed to the next step during menu or
auto setup operation and save the data.
Cli)
& (cursor) button
For selecting menu options displayed on the screen
in menu or auto setup operations. Each time this
button is pressed, the cursor moves downwards
and, if at the bottom, jumps to the top.
f])
RESET button
Press to reset an auto setup operation.
ED
ASU (automatic setup) lamps
CHROMA/PHASE:
Lights when the automatic
chroma and phase adjustment is completed with
AUTO CHROMA/PHASE in auto setup
operations. The lamp goes off when MANUAL
is selected on the SELECT MONITOR MEM
menu in auto setup operations.
WHITE BAL: Lights when one of the color
temperature to be transfered to the monitor by
the auto white balance adjustment is selected on
the SELECT MONITOR MEM menu in auto
setup operations. When this lamp is lit, the
color temperature selection on the SELECT
MONITOR MEM menu can be performed
using the WHITE BALANCE/8 button.
1. Operation
11-15
- Quick Links:
- Table of Contents
- Features
- Operation
- Rear Panel
Hide quick links:
Advertisement
Table of Contents
