Figure 16-11 Installing A Ds-3/E3 Cable With Minibnc Connectors - Cisco ONS 15310-MA SDH Procedure Manual

Hide thumbs Also See for ONS 15310-MA SDH:

Table of Contents

DLPs H1 to H99

Onsite/Remote

Security Level

Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. For

detailed instructions on how to wear the ESD wristband, refer to the

(ESD) and Grounding

Cisco recommends you use Cisco-orderable miniBNC cables to ensure interoperability between the

cables and miniBNC connectors on the ONS 15310-MA SDH.

Place a miniBNC cable connector over the connector on the front of the ONS 15310-MA SDH.

Figure 16-11

Position the cable connector so that the slot in the connector is above the corresponding notch on the

ONS 15310-MA SDH connection point.

Gently push the connector down until the notch on the ONS 15310-MA SDH connector slides into the

slot on the cable connector.

Turn the cable connector until the notch clicks into place.

Return to your originating procedure (NTP).

shows how to connect a coaxial cable to an ONS 15310-MA SDH.

Installing a DS-3/E3 Cable with MiniBNC Connectors

Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2

Cisco ONS Electrostatic Discharge

Show Quick Links

Chapters

Table of Contents