Table of Contents
Advertisement
Available languages
Available languages
8.
All-wheel super automatic
mode
i
All-wheel super automatic mode is recommended
for full testing of a four-wheel drive vehicle requiring
verification of the measured data.
8.1
Mode activation and deactivation
Step
¶
Activate all-wheel super automatic
mode.
¶
Deactivate all-wheel super automatic
mode.
8.2
Test sequence
!
Also heed the test instructions in the 4WD vehicle operating manual.
Step
1. Check prerequisites:
R
No vehicle on dynamometer!
R
Test routine selected.
R
"All-wheel super automatic" mode selected.
i
Each sub-task consists of two single wheel
measurements with direction reversal.
!
It is essential to comply with the test sequence
(sequence of sub-tasks)!
The rest of the test sequence is similar to super automatic mode (refer to Section 7).
Robert Bosch GmbH
All-wheel super automatic mode | BSA 43xx | 67
Principal features:
R
Specified test sequence (sub-tasks).
R
Automatic starting of measurements.
R
Automatic storage of measurement results.
R
Auto-termination of the order after a pre-configured
time period.
R
Automatic print-out of measurement results.
R
Suitable for four-wheel drive vehicles.
Remote control unit
+
+
+
Press one after the other
Press STOP
Result / Display
Left: Device identifier and current sub-task:
1 = Front axle.
2 = Rear axle.
P = Parking brake.
Right: Drive-on prompt.
Result / Display
Mode indicator:
"All-wheel super automatic" symbol
Mode indicator:
"Manual mode" symbol
1 691 606 210
en
|
2015-07-29
Advertisement
Chapters
Table of Contents
