Step 4: Door Removal & Adjustment - Thermador PROFESSIONAL PRO GRAND PRD364WLGU Installation Instructions Manual
Dual fuel ranges
Hide thumbs
Also See for PROFESSIONAL PRO GRAND PRD364WLGU:
- Use and care manual (36 pages) ,
- Installation instructions manual (84 pages) ,
- Installation instructions manual (68 pages)
Table of Contents
Advertisement
Available languages
Available languages
2. To remove the pallet bolts use (2) ½'' (13 mm)
wrenches, one to hold bolt at the bottom while the other
is loosening the nut at the top. Discard the wood
packing block inserts.
Figure 8: Removal of Shipping Bolts
3. PRDS48JDSGU/C models: To access the pallet bolt
located beneath the warming drawer, reach up and
behind the frame of the unit with one 1/2" wrench to
hold the nut at the top (see Figure 9). Use the second
wrench to loosen the bolt at the bottom. DO NOT
remove the warming drawer.
Figure 9: Removal of Bolts Beneath Warming Drawer
4. Carefully tilt the range back and remove it from the
pallet. Use additional help as required to remove from
pallet.
5. After transporting the range by furniture dolly close to
its final location, the range can then be tipped back
while the dolly is carefully removed.
6. THE FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION.
•
Steps 5 through 8 must be completed before the
range is placed in its final position.
Installation Instructions
STEP 4: Door Removal and
Adjustment
CAUTION
•
USE CAUTION WHEN REMOVING THE DOOR.
THE DOOR IS VERY HEAVY. Use both hands to
remove or replace the door. Failure to grasp the
oven door firmly and properly could result in
personal injury and product damage.
•
Make sure oven is cool and power to the oven has
been turned off before removing the door. Failure to
do so could result in electrical shock or burns.
•
With the door off, never release the levers and try to
close the hinges. Without the weight of the door, the
powerful springs will snap the hinges closed with
great force.
To Remove the Oven Door
1. Be sure to read the above
2. Open the door fully.
3. Flip hinge clip down. A
4. Close the door gently until it
5. Grasp the door firmly on the
6. Place the door in a safe and
CAUTION before attempting
to remove the door.
screwdriver may be require to
carefully pry the clip back.
stops against the hinge clips.
The open hinge clips will hold
the door open at a slight
angle, about 30°, from the
closed position.
ends of the door. Lift the door
up and out. There will be
some spring resistance to
overcome.
stable location.
Figure 10: Door Removal
English 13
Advertisement
Chapters
Table of Contents
