12.8 The SensiCare System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Départ/Pause
button, the maximum declared load
indicator goes off, the SensiCare System
starts the laundry load detection:
1. The appliance detects the load in the
first 30 seconds. In the programmes
where Time Manager is available,
during this phase the Time Manager
bars
placed below the time
digits play a simple animation. The
drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Départ/Pause
start the programme again. The
SensiCare phase can be repeated up to
three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
12.9 Interrupting a programme
and changing the options
When the programme is running, you
can change only some options:
1. Touch the Départ/Pause
The related indicator flashes.
2. Change the options. The given
is
3. Touch the button Départ/Pause
The washing programme continues.
12.10 Cancelling a running
programme
button to
1. Press the button Marche/Arrêt to
2. Press the button Marche/Arrêt again
There is also an alternative way of
cancelling:
The SensiCare detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Time Manager button.
The SensiCare System is
not available with all
programmes such as :Laine,
Rinçage and programmes
with short cycles.
information in the display changes
accordingly.
again.
cancel the programme and to
deactivate the appliance.
to activate the appliance.
If the SensiCare System has
completed and the water
filling has already started,
the new programme starts
without repeating the
SensiCare System. The
water and the detergent are
not drained out in order to
avoid waste. The display
shows the maximum
duration of the programme,
updating it about 20 minutes
after the starting of the new
programme.
ENGLISH
31
button.