Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Use and Care Manual
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO
EXCESSIVE MICROWAVE ENERGY
(a) Do not attempt to operate this oven with the door open
since open-door operation can result in harmful exposure
to microwave energy. It is important not to defeat or
tamper with the safety interlocks.
(b) Do not place any object between the oven front face and
the door or allow soil or cleaner residue to accumulate on
sealing surfaces.
Tools and Parts
Gather the required tools and parts before starting installation.
Tools needed
Phillips screwdriver
Parts needed
A UL listed or CSA approved conduit connector
UL listed wire nuts
Parts supplied
2 screws (single oven) or 4 screws (double oven)
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
All electrical connections should be made by a licensed, qualified
electrical installer.
Location Requirements
Make sure you have everything needed for correct installation. It is
the responsibility of the installer to comply with the installation
clearances specified in these instructions.
IMPORTANT: Observe all governing codes and ordinances.
Cabinet opening dimensions that are shown must be used. Given
dimensions provide minimum clearance with oven.
Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
Grounded electrical supply is required. See "Electrical
Requirements" section.
Electrical supply junction box should be located 3" (7.6 cm)
maximum below the support surface when the oven is
installed in a wall cabinet. Drill a 1" (2.5 cm) minimum diameter
hole in the right rear or left rear corner of the support surface
to pass the appliance cable through to the junction box.
Oven support surface must be solid, level and flush with
bottom of cabinet cutout. Floor must be able to support a total
weight (microwave and built-in oven) of 238 lbs (108 kg).
INSTALLATION REQUIREMENTS
(c) Do not operate the oven if it is damaged. It is particularly
important that the oven door close properly and that there
is no damage to the:
(1)
Door (bent),
(2)
Hinges and latches (broken or loosened),
(3)
Door seals and sealing surfaces.
(d)
The oven should not be adjusted or repaired by anyone
except properly qualified service personnel.
Product Dimensions
27" (68.6 cm) and 30" (76.2 cm) Ovens
E
D
27" (68.6 cm) models
A. 25 " (64.5 cm) recessed width
B. 42
" (107.8 cm) overall height
C. 26 " (67.9 cm) overall width
D. 23" (58.4 cm) max. recessed
depth
E. 41" (104.1 cm) recessed height
2
A
B
C
30" (76.2 cm) models
A. 28 " (71.2 cm) recessed width
B. 42
" (107.8 cm) overall height
C. 29 " (75.6 cm) overall width
D. 23" (58.4 cm) max. recessed
depth
E. 41" (104.1 cm) recessed height
Advertisement
Table of Contents
Related Manuals for Whirlpool GSC308PRQ
Summary of Contents for Whirlpool GSC308PRQ
-
Page 1: Installation Requirements
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY (a) Do not attempt to operate this oven with the door open (c) Do not operate the oven if it is damaged. It is particularly since open-door operation can result in harmful exposure important that the oven door close properly and that there to microwave energy. -
Page 2: Electrical Requirements
Installation Clearances Electrical Requirements If codes permit and a separate ground wire is used, it is 27" (68.6 cm) and 30" (76.2 cm) Ovens recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. -
Page 3: Installation Instructions
INSTALLATION INSTRUCTIONS 4. Remove bottom screw on each side of the oven trim. Prepare Oven for Installation 1. Decide on the final location for the oven. Locate existing wiring to prevent drilling into or severing wiring during installation. WARNING Excessive Weight Hazard Use two or more people to move and install oven. -
Page 4: Install Oven
6. Complete installation following instructions for your type of electrical connection: 3-Wire Cable from Power Supply 4-wire (recommended) IMPORTANT: Use the 3-wire cable from power supply where local 3-wire (if 4-wire is not available) codes permit connecting the frame-ground conductor to the neutral (white) junction box wire: Electrical Connection Options If your home has:... -
Page 5: Complete Installation
2. Push against seal area of front frame to push oven completely 9. Push hinges in as far as they will go and open the oven door. into cabinet and center oven into cabinet cutout. You should feel the oven door drop into place. 10. -
Page 6: Table Of Contents
INSTALLATION INSTRUCTIONS 27" (68.6 CM) AND 30" (76.2 CM) ELECTRIC BUILT-IN MICROWAVE/OVEN COMBINATION Table of Contents BUILT-IN MICROWAVE/OVEN SAFETY..1 INSTALLATION REQUIREMENTS ....2 Tools and Parts ..........2 Location Requirements......... 2 Electrical Requirements ........ 3 INSTALLATION INSTRUCTIONS ....4 Prepare Oven for Installation ......