Table of Contents
Advertisement
Available languages
Available languages
32 www.electrolux.com
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
11.3 Oven lamp
WARNING!
Be careful when you change the
oven lamp. There is a risk of elec-
trical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or
deactivate the circuit breaker.
Put a cloth on the bottom of the
oven to prevent damage to the
oven light and glass cover.
Always hold the halogen lamp
with a cloth to prevent grease res-
idue from burning on the lamp.
Removing the oven door and the glass panel
2
1
2.
Pull the rear end of the shelf support
away from the side wall and remove
it.
1.
Turn the glass cover counterclock-
wise to remove it.
2.
Clean the glass cover.
3.
Replace the oven light bulb with an
applicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4.
Install the glass cover.
11.4 Cleaning the oven door
The oven door has three panels of glass.
You can remove the oven door and the
internal glass panels to clean them.
The oven door can close if you try
to remove the glass panels before
you remove the oven door.
1.
Fully open the door and identify the
hinge to the right side of the door.
2.
Push the tightening component until it
pulls back.
Advertisement
Chapters
Table of Contents
