Installing Forms Tractor In Push-Pull Position; Installation Procedure (Front Push) - IBM 3 User Manual
4247 printer
Hide thumbs
Also See for 3:
- Installation and reference manual (72 pages) ,
- Quick installation manual (2 pages)
Table of Contents
Advertisement
Installing Forms Tractor in Push-Pull Position
This illustration shows the push-pull forms path from the left side of the printer.
Note: This forms path procedure assumes that both tractors are not installed in the
Installation Procedure (Front Push)
To install the forms tractor in the Front Push position:
1. The power switch is located on the lower left side of the printer. Ensure that
2. Open the front tractor cover to its locked position.
252
4247 Model 003 User's Guide
Paper Exit -
Push-Pull
printer and that one tractor is in the Push or fully-extended position and the
other tractor is in the Rear Pull or angled position. If neither one of the
tractors are in the Rear Pull or angled position, follow these steps for one of
the forms tractors before continuing with the Push-Pull procedure:
v Place the tractor face down on a flat surface with the electrical connector
tab on the right side, pointing toward you.
v Pull the bottom release levers toward you with your finger tips and pull
the movable edge of the tractor up away from the flat surface with your
thumbs (1) until the tractor locks in the angled position (2).
the printer is powered off (O) before removing or installing forms tractors.
Power Switch
Push-Pull
- Quick Links:
- Lan Attachment
Hide quick links:
Advertisement
Chapters
Table of Contents
