Table of Contents
Advertisement
3 Tests and Diagnostics
3.2
Executing the Diagnostic Test
To start the DIAGNOSTIC PROGRAM, follow these steps:
1. Insert the Diagnostics disk in the USB floppy disk drive.
2. Turn on the computer with pressing the U. Then, the following menu appears.
Repair test program
---------------------------------------------------------
1. Repair Main (T&D)
2. Repair initial config set
3. Repair Heatrun (T&D)
Select from Menu [1 2 3], or press [Enter] (Selection=1)
Singlestepping (F8) is: OFF
Select the program you want to execute.
To start the Diagnostics menu (T&D), press 1, or select (1) Repair Main and press Enter.
To start the H/W initial information setting tool, press 2, or select (2) Repair Initial config set
and press Enter.
To start the Heatrun test, press 3, or select (3) Repair Heatrun and press Enter.
NOTE: After replacing the system board or CPU, it is necessary to execute the subtest
01 Initial configuration in 3.3 Setting of the hardware configuration.
3-4
[CONFIDENTIAL]
3.2 Executing the Diagnostic Test
(XXXXXX/XXXXXXX)
Satellite R20/TECRA M7 Maintenance Manual (960-572)
Advertisement
Chapters
Table of Contents
Troubleshooting
