Toshiba QOSMIO G10 Maintenance Manual page 221
Hide thumbs
Also See for QOSMIO G10:
- User manual (235 pages) ,
- User reference manual (31 pages) ,
- User manual (276 pages)
Table of Contents
Advertisement
3.31 SETUP
7. Configuration
This option lets you set the device configuration.
All Devices
Setup by OS
NOTE: (1) When using installed OS, selecting "Setup by OS" is recommended.
(2) When executing test programs, be sure to select "ALL Device". And after
the test end, select "Setup by OS".
8. Drives I/O
This option displays the address and interrupt level for hard disk drive and optical
disk drive. It is for information only and cannot be changed.
Built-in HDD
CD-ROM
9. PCI Bus
This option displays the interrupt level for the Card Bus in the computer. It is for
information only and cannot be changed.
PCI BUS
10. Display
This group of options configures the computer's display.
(a) Power On Display
This option is used to select the display when booting up.
Auto-Selected
LCD+AnalogRGB
3-100
BIOS sets all devices.
Initializes devices, which is needed to load an operating
system. Operating system initializes other devices.
This cannot be changed.
This cannot be changed. This is not displayed when a drive
is not built-in.
= IRQ10, IRQ11
Selects an external monitor if one is connected.
Otherwise it selects the internal LCD. (Default)
Selects both the internal LCD and the external CRT for
simultaneous display.
3 Tests and Diagnostics
QOSMIO G10 Maintenance Manual (960-497)
Advertisement
Chapters
Table of Contents
Troubleshooting
