Parameter Names - Siemens SIDOOR AT40 System Manual
Automatic door control
Hide thumbs
Also See for SIDOOR AT40:
- System manual (337 pages) ,
- Operating instructions manual (6 pages) ,
- Operating instructions (4 pages)
Table of Contents
Advertisement
Controllers
4.7 Operating and parameterizing controllers
4.7.3
Parameter names
Some of the parameter names are abbreviated in the software because of the limited
number of characters in the display. The full names of the parameters are used in this
manual.
The following table shows the full parameter names and the equivalent names used in the
software:
Full parameter name
Profile parameter
Creep distance OPEN
Cutter distance OPEN
Creep distance CLOSE
Cutter distance CLOSE
Maximum speed OPEN
Creep speed OPEN
Cutter speed OPEN
Initial speed OPEN
Maximum speed CLOSE
Creep speed CLOSE
Cutter speed CLOSE
Initial speed CLOSE
Acceleration ramp OPEN
Braking ramp CLOSE
Reversing ramp OPEN/CLOSE
Acceleration ramp CLOSE
Braking ramp CLOSE
Reversing ramp CLOSE/OPEN
Continuous torque (power) OPEN
Continuous torque (power) CLOSE
Cutter press-on torque CLOSE
Static opening force
Static closing force
Static cutter force CLOSE
76
Parameter name as shown in the software
slow end open distance
slow start open distance
slow start close distance
slow end close distance
maximum speed open
slow end speed open
slow start speed open
slow speed open initial
maximum speed close
slow start speed close
slow end speed close
slow speed close initial
acceler. ramp open
Braking ramp OPEN
reversal ramp op/cl
acceler. ramp close
deceler. ramp close
reversal ramp cl/op
idle torque open
idle torque close
peak torque close
limit force open
limit force close
limit force end close
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC
- Quick Links:
- Learn Run
Hide quick links:
Advertisement
Table of Contents
