Table of Contents
Advertisement
MODEL B1
CUSTOMER ENGINEERING
Motor Adjusting Screw
Figure :1. Ring-Mounted Motor
POWER ROLL
1. Remove the front case.
2. The clutch should be latched before removing the
power roll. This precaution will serve to hold the
clutch parts in place when the shaft is removed,
thereby facilitating reassembly. It will be noted that
the right end of the power roll shaft is chamfered
for easy insertion into the clutch disc slot.
3. Remove the driven belt from the power roll drive
pulley.
4. Loosen the two setscrews in the power roll drive
pulley and remove the pulley (Figure 3).
5. Remove the three screws holding the bearing retainer
to the left side frame.
6. Remove the power roll assembly through the hole in
the left side frame.
Power Roll
Drive
Pulley
Figure
3.
Power RoIl Removal
"
Advertisement
Chapters
Table of Contents
