Table of Contents
Advertisement
REFERENCE
MANUAL
ATTACHMENTS
~ensi"i
Wires
Contact Plate Springs
Canloct Plate
Sensi
Fi
... Stud
Fig. 2. Electronic Tab Sensing Mechanism
2.
SENSING FINGERS
The sensing fingers and contact plate are mounted on
the front rail dust cover in the area formerly occupied by
the right hand line gage card holder. The contact plate
is held in a fixed position, while the sensing finger is
free to rotate.
The left hand line gage card holder has
been relieved to permit the sensing finger to be pivoted
down and away from the paper when in its rest position
(Figure 1). The sensing finger should
be adjusted so that
when it is in the upright or operating position, the sensing
wires will rest lightly against the platen.
At the same
time the body of the sensing finger should be approximately
Upright Stud on
.
Rear
Rail
Rebound Check Lever
J7r
Mognet
/' r
Armatur.
Not.: Rebound check stop
upright lug is hidden
unci ... exlens Ion
Fig. 3. Electronic Tab Latching Mechanism
7
Advertisement
Chapters
Table of Contents
