Table of Contents
Advertisement
20 Start-up guide for ACS880 winder control program
Drive start-up
Before you start
Make sure that the drive has been mechanically and electrically installed as
described in the appropriate Quick installation guide and/or Hardware manual.
Safety
WARNING! All electrical installation and maintenance work on the drive should
be carried out by qualified electricians only.
Never work on the drive, the braking copper circuit, the motor cable or the motor
when power is applied to the drive. Always ensure by measuring that no voltage is
actually present.
Start-up
WARNING! Obey all safety instructions for the drive. Only qualified electricians are
allowed to start up the drive.
Check the installation. See the installation checklist in the appropriate Hardware manual.
Check that the starting of the motor does not cause any danger.
De-couple the driven machine if
• there is a risk of damage in case of an incorrect direction of rotation, or
• a Normal ID run is required during the drive start-up, when the load torque is higher
than 20% or the machinery is not able to withstand the nominal torque transient during
the ID run.
Power up the drive.
Note: It is normal that warning messages
appear at various points along the start-up
process. To hide a message and to resume
the start-up process, press
Hide any warnings now to enter the Home
view (shown on the right).
The two commands at the bottom of the
display (in this case, Options and Menu),
show the functions of the two softkeys
and
located below the display. The
commands assigned to the softkeys vary
depending on the context.
Safety
1 – Power-up, date and time settings
.
Remote
Motor speed used
rpm
Motor current
A
Motor torque %
%
Options
12:34
0.0 rpm
0.00
0.00
0.0
Menu
- Quick Links:
- Modbus Holding Register Addresses
Hide quick links:
Advertisement
Chapters
Table of Contents
