Table of Contents
Advertisement
352 Parameters
No.
Name/Value
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
40.50
Set 1 tracking ref
selection
Not selected
AI1 scaled
AI2 scaled
FB A ref1
FB A ref2
Other
40.51
Set 1 trim mode
Off
Direct
Proportional
Combined
40.52
Set 1 trim selection
Torque
Speed
Frequency
40.53
Set 1 trimmed ref
pointer
Not selected
AI1 scaled
AI2 scaled
FB A ref1
Description
Digital input DI2
(10.02 DI delayed
Digital input DI3
(10.02 DI delayed
Digital input DI4
(10.02 DI delayed
Digital input DI5
(10.02 DI delayed
Digital input DI6
(10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see
Terms and abbreviations
152).
Selects the value source for tracking mode. See parameter
40.49 Set 1 tracking
mode.
None.
12.12 AI1 scaled value
(see page 197).
12.22 AI2 scaled value
(see page 198).
03.05 FB A reference 1
03.06 FB A reference 2
Source selection (see
Terms and abbreviations
152).
Activates the trim function and selects between direct and
proportional trimming (or a combination of both). With
trimming, it is possible to apply a corrective factor to the
drive reference (setpoint). The output after trimming is
available as parameter
See the control chain diagram on page 659.
The trim function is inactive.
The trim function is active. The trimming factor is relative to
the maximum speed, torque or frequency; the selection
between these is made by parameter
selection.
The trim function is active. The trimming factor is relative to
the reference selected by parameter
pointer.
The trim function is active. The trimming factor is a
combination of both
Direct
proportions of each are defined by parameter
trim
mix.
Selects whether trimming is used for correcting the speed,
torque or frequency reference.
Torque reference trimming.
Speed reference trimming.
Frequency reference trimming.
Selects the signal source for the trim reference.
None.
12.12 AI1 scaled value
(see page 197).
12.22 AI2 scaled value
(see page 198).
03.05 FB A reference 1
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed
status, bit 0).
(11.02 DIO delayed
status, bit 1).
(see page 160).
(see page 160).
40.05 Process PID trim output
40.52 Set 1 trim
40.53 Set 1 trimmed ref
and
Proportional
modes; the
40.54 Set 1
(see page 160).
Def/FbEq16
3
4
5
6
7
10
11
on page
-
Not selected
0
1
2
3
4
on page
-
Off
act.
0
1
2
3
Torque
1
2
3
Not selected
0
1
2
3
- Quick Links:
- Modbus Holding Register Addresses
Hide quick links:
Advertisement
Chapters
Table of Contents
