Table of Contents
Advertisement
Application fault messages
Code
Fault
(hex)
E100
Web Loss
1
2
Cause
The processed material (web,
wire or cable) may be broken.
Speed error detected by speed
error watchdog is below the
tripping level set with
parameter
81.04 Speed error
low
%.
Tension or dancer feedback
signal is below the tripping
level set with parameter
Speed error low
%.
What to do
If the material is not broken, check the
settings of parameter group
safety.
Check the event log for an auxiliary code.
See appropriate actions for each code
below.
If the material is not broken, increase the
overspeed settings in parameter group
75 Winder speed settings
75.31 Overspeed ref offset
Dynamic offset
If the material is not broken, check the
settings of parameter group
81.04
safety.
Especially check the parameter
Speed error low %
Fault tracing 605
81 Winder
(parameters
and
75.32
trim).
81 Winder
81.04
for too high value.
- Quick Links:
- Modbus Holding Register Addresses
Hide quick links:
Advertisement
Chapters
Table of Contents
