Replacing A Pci Riser-Card Assembly - IBM x3690 X5 Service Manual

Hide thumbs Also See for x3690 X5:

Table of Contents

6. Remove the adapter, if necessary, from the PCI riser-card assembly.

7. Set the adapter and PCI riser-card assembly aside.

Replacing a PCI riser-card assembly

To replace a PCI riser-card assembly, complete the following steps:

1. Read the safety information that begins on page "Safety" on page vii and the

"Installation guidelines" on page 261.

2. Install the adapter in the new PCI riser-card assembly (see "Replacing an

adapter" on page 275).

3. Set any jumpers or switches on the adapter as directed by the adapter

manufacturer.

4. Align the PCI riser-card assembly with the PCI slot connector on the system

board and align the nailheads with the slots on the chassis; then, press down

firmly until the PCI riser-card assembly is seated correctly in the connector on

the system board.

Chapter 5. Removing and replacing components