Page 1
Operator’s manual WARNING Before using our products, please read this manual 130BT carefully to understand the proper use of your unit. 350BT 370BTS 380BTS English APPLICABLE SERIAL NUMBERS: 00100101 and up 115 31 90-26 Original Instructions...
Page 2
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel +46-36-146500, declares under sole responsibility that the blowers Husqvarna 130BT, 350BT, 370BTS, 380BTS with serial numbers dating 2010 and onwards (the year is clearly stated on the rating plate, followed by the serial number), comply with the requirements of the COUNCIL’S DIRECTIVE: - of May 17, 2006 “relating to machinery”...
English Safety NOTES ON TYPES OF WARNINGS SAFETY FIRST WARNING Instructions contained in warnings within this manual and Instructions labeled as shown above, concern critical steps warning seals marked with a symbol on the blower concern or procedures which must be followed in order to prevent critical points which must be taken into consideration to prevent accidents which could lead to serious bodily injury or possible serious bodily injury, and for this reason you are...
Operator’s manual. note that you are requested to contact the dealer from whom you 10. Husqvarna AB has a policy of continuous product purchased the product for development and therefore reserves the right to modify assistance the event that you have...
3. Never operate the machine in high wind, bad weather, potentially explosive atmosphere, when visibility is poor or in very high or low temperatures. (Our recommended use environment is below 40 degrees C (104 degrees F).) 130BT 350BT, 370BTS, 380BTS...
Doing est Husqvarna servicing dealer for assistance. Checking so may result in being subjected to an the fan is very important. If the rotating fan should break up, electrical shock.
Improper service to the blower fan and muffler could cause a hazardous failure. 5. When replacing the any other part or any lubricant, always be sure to use only Husqvarna products or products which have been certified by Husqvarna for use with the Husqvarna product.
English What is what? <130BT> 1. Frame 16. Control handle 2. Harness 17. Stop Switch with Throttle Position Setting 3. Engine Cover 18. Throttle Lever 4. Volute Case, Cover 19. Handle Bar (Option) 5. Net 20. Elbow 6. Fan 21. Clamp (large) 7.
Page 10
English What is what? <350BT> 1. Frame 15.Control handle 2. Harness 16.Stop Switch with Throttle Position Setting 3. Engine Cover 17.Throttle Lever 4. Volute Case, Cover 18. Handle Bar (Option) 5. Net 19. Elbow 6. Fan 20. Clamp (large) 7. Air Cleaner 21.
Page 11
English What is what? <370BTS> 1. Frame 15.Control handle 2. Harness 16.Stop Switch with Throttle Position Setting 3. Engine Cover 17 Throttle Lever 4. Volute Case, Cover 18. Handle Bar (Option) 5. Net 19. Elbow 6. Fan 20. Clamp (large) 7.
Page 12
English What is what? <380BTS> 1. Frame 15. Control handle 2. Harness 16.Stop Switch with Throttle Position Setting 3. Engine Cover 17.Throttle Lever 4. Volute Case, Cover 18.Handle Bar (Option) 5. Net 19. Elbow 6. Fan 20. Clamp (large) 7. Air Cleaner 21.
English Technical data MODEL 130BT 350BT 370BTS 380BTS Dimensions (L x W x H) mm 295x387x432 351x446x479 365x464x485 410x509x497 Dry Weight kg (lbs) (including pipe) 6.75 10.2 13.2 Dry Weight kg (without accessories) 11.2 12.4 Fuel Tank Capacity liter 1.25 1.75...
(1) Cabling (2) Flexible Hose CABLING 130BT • Fasten the cabling at central position of the hose by the band attached to the cabling. First, wrap the flexible hose with the band fixed to the cabling from the lower side.
• The waist belt is attached to the rings on the left and right sides of the frame. NOTE 130BT has no waist belt. Place the waist belt around your waist and not too far down on the stomach. Tighten the waist belt strap so that you feel the weight of the blower resting on your hip.
4. Do not smoke or place hot objects near fuel. 2-cycle gasoline engine use. If Husqvarna oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2- cycle engine use. (JASO FC GRADE OIL or ISO EGC GRADE) •...
That will reduce the cooling air and the engine could be damaged by overheating. 1. Push the primer bulb until fuel flows out in the clear tube. 2. When the engine is cool, close the choke. (1) Choke Lever (130BT) (2) Primer Bulb (3) OPEN (4) CLOSE (350BT) (370BTS, 380BTS) 3.
• The idling speed is set for 3000 rpm at the factory. If it is necessary to adjust the idle speed, use the adjustment screw on the top side of carburetor. (1) Idling Adjustment Screw (130BT, 350BT) 350BT, 370BTS, 380BTS • The idling speed is set for 2200 rpm (350BT) or 2000 rpm (370BTS/380BTS) at the factory.
• Never clean the paper filter by tapping on it. Doing so may break the element, causing dust to get sucked into the blower and damaging the engine. CLEANING AIR FILTER: (130BT) (F24) 1. Unscrew the knob and remove the air cleaner cover. (1) Knob...
SPARK ARRESTER • The muffler is equipped with a spark arrester to prevent red hot carbon from flying out of the exhaust outlet. Periodically inspect and clean as necessary with a wire brush. (130BT) (1) Bolt (2)Bolt (3) Spark Arrester...
• Note that failure to remove any such obstacles may result in the engine becoming overheated and damaged. (1) Net WARNING (130BT) Never use the blower without the net on the blower. Before each use, check that the net is attached in place and is free from any damage. (350BT, 370BTS, 380BTS) SHOLDER STRAP •...