Download Print this page

Nectre Fireplaces 800 Operating Instructions Manual page 8

Wall fire heater

Hide thumbs Also See for 800:

Table of Contents

Flue Requirements

Install a 150mm diameter double cased flue kit to comply with AS 2918. Fit an

additional 300 mm diameter outer casing from the heater to a minimum of 300

mm above the ceiling having bent tabs or spacers to ensure a 25 mm clearance

to the flue outer is maintained. A hole of 350 mm diameter is required in the

ceiling and a 25 mm clearance between any combustible material and the 300

mm outer casing. Refer to diagram below.

Fit the outer trim using the four 4mm screws. This is best achieved with the door

open.

The fire is now ready to use. Note the first few firings will cure the paint. Keep the

room well ventilated whilst this is happening as fumes are given off.

Table of Contents

Show Quick Links

Table of Contents