Siemens SINUMERIK 840D sl Programming Manual page 319

Measuring cycles

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Measuring variant

Radial position,

Measuring without

4 measurements

Direction of

measurement for

determining length L1

opposite to traversing

direction, measuring

procedure as for

_MVAR=x13002 but with

different traversing

Length measurements

for L1 (P3, P4) are

performed here at the

same measuring point –

without rotating the

spindle by 180 degrees.

The same cutting edge is

always measured

(starting angle _STA1).

The width of the milling

tool must be considered

when selecting the

starting position or

dimension a!

Measuring cycles

Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0

6.3 CYCLE982 tool: Measure turning and milling tools

Offset applied

Measuring Cycles for Turning Machines

Milling tools