Thermador VTR1400Q Installation Instructions Manual
Roof or wall ventilator
Hide thumbs
Also See for VTR1400Q:
- Installation instructions (4 pages) ,
- Installation instructions manual (8 pages)
Advertisement
Available languages
Available languages
Quick Links
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
IMPORTANT: Save these instructions for the Local Electrical Inspector's use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
SAFETY WARNING: Before servic-
ing or cleaning unit, switch power off
at the service panel and lock service
disconnecting means to prevent
power from being switched on acci-
dentally. When the service discon-
necting means cannot be locked, at-
tach a tag to the service panel to
indicate power has been switched off
for maintenance.
WARNING - TO REDUCE
THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PER-
SONS, OBSERVE THE FOL-
LOWING:
Recommended for use only over conventional domestic gas and electric ranges, and
I. INSTALLATION:
1. Remove and discard shipping bracket (attached to mo-
tor mounts and inlet collar). Check to see if blower
wheel turns freely. Do not replace top until installation
is complete.
2. Provide a square cutout through the roof (or wall) as
shown by the dashed lines, or cut a round hole to fit duct
with a separate hole for electrical conduit as shown by
solid lines in Fig. 1.
3. Install the remote ventilator with the discharge pointing
down slope as shown in Figures 3 and 4. Follow standard
roofing procedures. Install the ventilator so the dis-
charge edge is on top of the shingles and the rear edge
is underneath the shingles.
OWNER: Please retain these instructions for future reference.
IMPORTANT SAFETY INSTRUCTIONS
A. Installation work and electrical wir-
ing
person(s) in accordance with all
applicable codes & standards, in-
cluding fire-rated construction.
B. Sufficient air is needed for proper
combustion and exhausting of gases
through the flue (chimney) of fuel
burning equipment to prevent back
drafting. Follow the heating equip-
ment manufacturers guideline and
safety standards such as those pub-
lished by the National Fire Protec-
tion Association (NFPA), and the
American Society for Heating, Re-
frigeration and Air Conditioning En-
READ AND SAVE THESE INSTRUCTIONS
use with an approved Thermador Hood.
INSTALLATION INSTRUCTIONS
ROOF OR WALL VENTILATOR
MODEL VTR1400Q, VTR1000Q & VTR600R
must be done by qualified
Fig. 1 TOP VIEW Down Slope of Roof or Wall
Model
VTR600R
VTR1000Q 7-1/4"
VTR1400Q 7-1/4"
1
gineers (ASHRAE), and the local
code authorities.
C. When cutting or drilling into wall or
ceiling, do not damage electrical
wiring and other hidden utilities.
D. To properly exhaust air, be sure to
duct air out side. Do not vent
exhaust air into spaces within walls,
ceilings, attics, crawl spaces, or ga-
rages.
WARNING: To reduce the risk
of fire, use only metal ductwork.
CAUTION - For General Ventilat-
ing Use Only.
Do Not Use To
Exhaust Hazardous Or Explosive
Materials And Vapors.
Dim.
A
B
C
5-11/16" 6-1/8"
9"
6-15/16" 11"
6-15/16" 11"
Advertisement
Related Manuals for Thermador VTR1400Q
Summary of Contents for Thermador VTR1400Q
- Page 1 INSTALLATION INSTRUCTIONS ROOF OR WALL VENTILATOR MODEL VTR1400Q, VTR1000Q & VTR600R PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. IMPORTANT: Save these instructions for the Local Electrical Inspector’s use. INSTALLER: Please leave these Installation Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference.
- Page 2 VTR600R and 10" dia. duct for VTR1000Q circuit panel to the wall box. See Figure 8. and VTR1400Q. Use adjustable elbow to adjust to roof 4. Run electrical conduit per local code to conduit angle. Tape all joints to prevent air leaks.
- Page 3 5. For best performance duct runs should be as short and as straight as possible. Where turns are neces- sary, keep turning radius as large and as smooth as possible. (not provided) Fig. 8 VTR600R/VTR1000Q/VTR1400Q: WIRING DIAGRAM FOR WALL MOUNT FOUR (4) POSITION SWITCH MODEL # CTR3Q...
- Page 4 BSH reserves the right to change specifications or design without notice. Some models are certified for use in Canada. BSH is not responsible for products which are transported from the United States for use in Canada. Check with your local Canadian distributor or dealer. For the most up to date critical installation dimensions by fax, use your fax handset and call 702/833- 3600.
-
Page 5: Instructions De Sécurité Importantes
INSTRUCTIONS D'INSTALLATION VENTILATEUR PAR LE TOIT OU LE MUR MODÈLES VTR1400Q, VTR1000Q ET VTR600R LIRE ENTIÈREMENT LES INSTRUCTIONS AVANT DE PROCÉDER. IMPORTANT : Conserver ces instructions à des fins d'utilisation pour l'inspecteur en électricité. INSTALLETEUR : Laisser les instructions d'installation avec l'appareil pour le propriétaire. - Page 6 8 po de diamètre pour le VTR600R et de 10 po 4. Acheminer le conduit électrique selon le code local à la de conduit pour le VTR1000Q et VTR1400Q. Utiliser des sortie au bas du ventilateur comme montré à la figure 5.
- Page 7 Ventilateur interrupteur au mur Modèle (non fourni) CTR3Q ou SSC1C (VTR600R seulement (non fourni) Fig. 8 VTR600R/VTR1000Q/VTR1400Q : DIAGRAMME DE CÂBLAGE POUR FIXATION AU MUR, INTERRUPTEUR 4 POSITIONS, MODÈLE N° CTR3Q Blanc (Commun) Moteur de Blanc (Commun) Interrupteur soufflerie...
- Page 8 Thermador se réserve le droit de modifier les données techniques ou le design sans préavis. Certains modèles sont certifiés pour une utilisation au Canada. Thermador n’est pas responsable des produits expédiés des États- Unis au Canada. Vérifier avec le distributeur canadien local.
-
Page 9: Aviso De Seguridad
LEA Y GUARDE ESTAS INSTRUCCIONES Se recomienda el uso sólo encima de estufas eléctricas o de gas domésticas convencionales, y se debe usar con una campana aprobada por Thermador. Fig. 1 VISTA SUPERIOR Pendiente del Techo o Pared I. INSTALACIÓN: 1. - Page 10 8 pulg. de diámetro para VTR600R y un ducto con10" eléctrico a la caja de pared. Vea la Figura 8. de diámetro para VTR1000Q y VTR1400Q. Use codos ajustables para ajustarse al ángulo del techo. Aisle todas 4. Ponga el conducto eléctrico de acuerdo al código local a la las juntas con cinta para evitar fugas.
- Page 11 Modelos CTR3Q o SSC1C (VTR600R solo) (no incluido) (no incluido) Fig. 8 VTR600R/VTR1000Q/VTR1400Q: DIAGRAMA DE CONEXIONES PARA MONTAJE EN PARED DEL REGULADOR DE CUATRO (4) POSICIONES, MODELO # CTR3Q blanco (común) motor de blanco (común) interruptor...
- Page 12 BSH se reserva el derecho de modificar las especificaciones o el diseño sin previo aviso. Algunos modelos están certificados para ser usados en Canadá. BSH no es responsable de productos que son transportados desde los Estados Unidos para ser utilizados en Canadá. Consulte a su distribuidor local en Canadá. Para recibir la información más crítica con respecto a las dimensiones de instalación por fax, utilice su fax y llame al 775/833-3600.