Hamilton Beach OG02 Assembly And Operation Manual page 19

Hamilton beach type og02 gas grill assembly and operation manual

Hide thumbs Also See for OG02:

Table of Contents

STEP 11: Side Burner

8. Reattach side burner to side burner shelf with the 2 previously removed screws as shown in Fig.11j.

9. Push control knob onto side burner valve stem as shown in Fig.11k.

10. Insert the small tip of the side burner wire into the socket of side burner shown in Fig.11l

and Fig.11m. Secure by pressing on with white cap as shown in Fig.11n.

Also please note Fig.11l, Fig.11m and Fig.11n, these three views are of the underside of the right

side shelf, looking towards the front of the grill from the rear.

11. Place side burner grate on side burner as shown in Fig.11o.

12. The side burner is now fully assembled. This step (step 12) is only necessary if you find later that

you cannot light the side burner by using the side burner knob. Often, this is caused by poor

alignment of the igniter tip with a hole in the side burner. To adjust this alignment, grab the igniter tip

with a pair of needlenose pliers as shown in Fig. 11p. Using gentle force, move the position of the tip

so it is about 1/8" from the bottom of one of the holes in the burner, as shown in Fig. 11q.

Fig.11j

Fig.11m

ASSEMBLY STEPS

Fig.11p

Fig.11k

Fig.11n

Fig.11q

Fig.11l

Fig.11o

Table of Contents