Final Installation Checklist; Grill Lighting Instructions - Hamilton Beach OG02 Assembly And Operation Manual

Hamilton beach type og02 gas grill assembly and operation manual

Hide thumbs Also See for OG02:

Assembly & operation manual (84 pages)

Operation manual (84 pages)

Assembly and operation manual (84 pages)

Table Of Contents

Table of Contents

POST-ASSEMBLY

At least 36" (91-cm) clearance must be maintained from combustible constructions to the

□

sides and back of the grill.

There is no combustible construction material over the grill.

□

All internal packaging is removed.

□

Burners are sitting properly on orifices. The orifice of the valve must be located in the center

□

of the burner section after removal and cleaning. Otherwise, it may cause serious bodily injury

and property damage. Swing the burner slightly after replacing to check whether it has been

installed properly.

Knobs turn freely.

□

The regulator and hose connected to the grill are provided by the manufacturer (preset for 11"

□

[28-cm] water column).

Unit tested and free of leaks.

□

User informed of gas supply shut-off valve location.

□

ALWAYS INSPECT THE HOSE PRIOR TO EACH USE.

BEFORE LIGHTING:

• Inspect the gas supply hose before turning the gas ON. If there is evidence of cuts, wear, or

abrasion, it must be replaced before use. The replacement hose assembly must be that specified

by the manufacturer.

TO LIGHT MAIN BURNERS OF THE GRILL:

Read all instructions before lighting.

1. Open the lid and make sure all knobs are in the "OFF" position. Fig.17

2. Push and turn the knob slowly counter clockwise to the ignite position

Keep pushing until the burner lights, then release. Repeat for additional burners.

3. If burner does not light, immediately turn the control knob to the "OFF" position and repeat

step 2.

4. If burner does not light after step 3, TURN OFF GAS SUPPLY and WAIT 15 MINUTES for the

gas to disperse then repeat steps 1 and 2 or light with external flame.

Shutdown instructions:

1.Turn all control knobs to the "OFF" Position.

2.Turn gas supply off at the tank.