Hitachi SH7032 Hardware Manual page 233

Superh risc engine

Table of Contents

SuperH microcomputer

Note: The read/write direction is decided by the RS3-RS0 bits in the CHCRn registers. If

RS3–RS0 = 0010, the direction is as shown in case 1 (circled number above); if RS3–

RS0 = 0011, the direction is as shown in case 2. In the Electrical Characteristics section,

DACK output (read) indicates case 1, and DACK output (write) indicates case 2.

Two types of transfers are possible in single address mode: 1) transfers between external

devices with DACK and memory-mapped external devices, and 2) transfers between external

devices with DACK and external memory. The only transfer request for either of these is the

external request (DREQ). Figure 9.7 shows the DMA transfer timing for single address mode.

The DACK output when a transfer occurs from an external device with DACK to a memory-

mapped external device is the write waveform. The DACK output when a transfer occurs from

a memory-mapped external device to an external device with DACK is the read waveform.

The settings of the acknowledge mode (AM) bits in the channel control registers (CHCR0,

CHCR1) have no effect.

External address bus

Figure 9.6 Data Flow in Single Address Mode

External data bus

External device

Show Quick Links

Chapters

Table of Contents